Adjustments
CE Marked Models
Loading door switch is factory adjusted to turn off when the door is opened a maximum of 3 inches
(76 mm). If adjustment is needed, refer to Figure 21 and follow these steps:
1.Start tumbler, following the operating instructions which accompanied it.
2.Slowly open loading door. Cylinder and heating system should stop when door is open 3 inches (76 mm) maximum.
3.Slowly close loading door while depressing start switch or pad. Tumbler should start before loading door is 0.5 inch (13 mm) from fully closed.
4.If opening the loading door 3 inches (76 mm) maximum does not stop tumbler, adjust switch.
5.Loose lower screw on switch coupler (use 2 mm hex wrench).
6.Align screw slot with alignment marks on switch top (switch should be closed, or on).
7.Start tumbler.
8.Prop door open 2.5 inches (63 mm).
9.Slowly rotate switch coupler counterclockwise (viewed from above switch) until tumbler stops.
10.Tighten lower screw on switch coupler.
11.Return to step 1 to verify loading door switch operation.
1
2
3
T495I
1Loading Door Switch
2Screw Slot
3Switch Coupler
Figure 21
50 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 70256801 |