Sprint Nextel M520 manual Resetting Digit Dial Adaptation, Screen, Press OK left softkey

4.Wait for the beep, and then repeat the digits using a normal tone of voice. (The phone plays back your first set of digits and asks “Did the recording sound OK?”)

If the recording is acceptable (no mistakes and no background noises), say “Yes” or press the left softkey.

If you need to rerecord the digits to fix any problems, say “No” or press the right softkey. (The phone then prompts you to say the digits again.) Wait for the beep, and then record the digits again. (Repeat this step until you are satisfied with the recording.)

5.After confirming that the recording is acceptable, repeat the recording process with the next set of digits.

6.Repeat steps 4 and 5 for an additional nine sets of digits.

7. When you are finished with a full session, you will
reach a screen that reads, “Adaptation Complete.”		Services
You can either allow the screen to time out or
press OK (left softkey) to return to the main standby
screen.		Voice
Note	It is recommended that you perform the complete
	adaptation of Digit Dial at least once to achieve the
	maximum benefit of this feature. If a partial adaptation
	is performed, you can always return later and resume
	the process from the halfway point.

Resetting Digit Dial Adaptation

1.While in standby mode, select Main Menu > Tools > Voice Services.

2.Press Settings (left softkey) > Digit Dialing > Reset Digits.

3.Press OK (left softkey).

Section 2H. Voice Services 89