2.Equipment connection and network setting
2.Equipment connection and network setting
2.1 Required equipment preparation
The following equipments are required to connect the projector to your PC through the network.
■ Common The projector: 1 unit, PC : 1 set *1
It is recommended to install the “Live Viewer 3” into the PC.
■ Depending on how you want to connect
1) For the wired connection
LAN cable
2) For the wireless connection *2 - Projector side
The Wireless Network Card (option : VA0833x *4) : 1 unit - PC side
IEEE802.11b/g wireless LAN equipment: 1 unit *3
*1: For the PC, please refer to the item 3.2.1 Minimum PC hardware and software requirement. (&23)
*2: An access point is required when the wireless LAN connection is used as Infrastructure mode.
*3: Depending on the type of wireless network device and PC you are using, the projector may not be able to communicate properly with your PC, even if the PC you are using is equipped with
To eliminate communication problems, please use a
*4: For more information, please consult your dealer.
2.2 Quick connection
The “Live Viewer 3” supports very quick and simple connection to the network. It is strongly recommended to install the “Live Viewer 3” into your PC to enjoy the feature. Proceed to the installation of the “Live Viewer 3” (&23) and the connection. (&26)
In case you don’t want to use the “Live Viewer 3” or you cannot use it by some reason, proceed to the manual setting, the item 2.3 for the wired LAN (&11) and the item 2.4 for the wireless LAN. (&16)
10
