Stovax PR0776 Installation, Unpacking, Control Upgrade, Safety Precautions, E-Studio Bf, E-Box Bf

INSTALLATION INSTRUCTIONS

INSTALLATION

1.UNPACKING

1.1• Remove the appliance from its packaging, and check that it is complete and undamaged

•Put the loose ceramic parts to one side so that they are not damaged during installation.

2.CONTROL UPGRADE

2.1Your fire is fitted with a control valve that can be easily upgraded to battery powered remote control. This upgrade can be fitted by anyone capable of simple DIY jobs and requires no special training. This upgrade can be obtained through your local Gazco stockist.

2.2STANDARD REMOTE CONTROL This remote control can control the fire after the pilot has been lit. It can turn the main burner on and regulate it from low through to high and back again. It can turn the main burner off leaving the pilot burning. GAZCO PART NUMBER 8455.

2.3PROGRAMMABLE THERMOSTATIC AND TIMER REMOTE CONTROL. This remote control can control the gas appliance after the pilot has been lit. In MANUAL MODE it can be used to turn the main burner on and manually regulate it from low through to high and back again. It can be used to turn the main burner off, leaving the pilot burning. In AUTO MODE it will automatically regulate the room temperature to a pre-set temperature. In

TIMER MODE it will turn the fire on and off according to pre-set programme and automatically regulate the room temperature during the two periods. GAZCO PART NO. 8456.

3.SAFETY PRECAUTIONS

3.1This appliance must be installed in accordance with the rules in force, and used only in a sufficiently ventilated space. Please read all instructions before installation and use of this appliance.

3.2These instructions must be left intact with the user.

3.3Do not attempt to burn rubbish on this appliance.

3.4In your own interest, and those of safety, this appliance must be installed by a competent person in accordance with local and national codes of practice. Failure to install the appliance correctly could lead to prosecution.

3.5Keep all plastic bags away from young children.

4. INSTALLATION OF THE GAS SUPPLY

	E-STUDIO BF
NAT GAS @ 20MB		PROPANE @ 37mb
8692BFCHUC		P8692BFCHUC
	E-BOX BF
NAT GAS @ 20MB		PROPANE @ 37mb
8692MCUC		P8692MCUC
8692PBUC		P8692PBUC

TO CHANGE FROM ONE GAS TYPE TO ANOTHER A COMPLETE ENGINE ASSEMBLY WILL BE REQUIRED.

SEE SECTION 12 REPLACING PARTS.

4.1Before installation, ensure that the local distribution conditions (identification of the type of gas and pressure) and the adjustment of the appliance are compatible. See table above.

4.2The position of the gas inlet pipe is shown, Diagram 3.

3

AR1467

4.3All supply pipes must be purged of any debris that may have entered, prior to connection to the appliance.

4.4The gas supply enters through the silicone panel located on the rear of the outer box. This will need to be slit with a sharp knife prior to passing the supply pipe through.

5.PREPARING THE APPLIANCE

5.1Remove the backing from the self-adhesive silicone sealing strip and apply to the rear flange of the firebox ensuring that the strip is positioned as close to the outer edge as is practically possible, Diagram 1, arrow A.

16