SUB - ZERO I N T E G R AT E D USE & C ARE
TO P CO M PA RT M E N T STORAGE
DELI DRAWER AND SHELF
The
Remove this assembly in much the same way you remove the standard adjustable shelves in the tall unit. See the instructions and illustra- tion for Adjustable Glass Shelves on page 13.
CRISPER – MODEL ICB736TCI
The sealed crisper in Model ICB736TCI offers convenient storage of fruits and vegetables and comes with two dividers.
To remove the crisper, the glass shelf must first be taken out by lifting the glass off of the plastic side supports. Next, lift the crisper bin up off of the bin cradle. Refer to the illustration below.
To replace the crisper, place the bin on top of the bin cradle. The groove across the bottom of the bin should align with the crossbar at the front of the cradle. Next, place the glass shelf on top of the side plastic side supports.
D R AW E R STORAGE
DRAWER REMOVAL
IMPORTANT NOTE: Before removing the top drawer from a base unit, you must first disconnect the control cable as shown in the illustration below.
To remove a storage drawer from your Integrated tall or base unit, pull it open until it stops. Raise the drawer front and pull out as shown in the illustration.
To replace a drawer, raise the front of it and place onto the tracks. Engage the hook at the rear of each slide with slots in the back of the drawer tub. For 914 mm wide units, there are tabs on each drawer that must be positioned between the hooks. Then engage the small white pegs at the front of each drawer slide with holes at the front of the drawer tub.
You must first disconnect the control cable before removing the top drawer of a base unit.
Crisper – Model ICB736TCI | Control cable | Storage drawer removal |
disconnection
14
