![](/images/new-backgrounds/1191822/19182255x1.webp)
SUPERSERVER
3-3 Control Panel LEDs
Each of the two control panels located on the front of the
Overheat/Fan Fail
When this LED flashes, it indicates a fan failure. When on continuously it indicates an overheat condition, which may be caused by cables obstructing the airflow in the system or the ambient room temperature being too warm. Check the routing of the cables and make sure all fans are present and operating normally. You should also check to make sure that the chassis covers are installed. Finally, verify that the heatsinks are installed properly (see Chapter 5). This LED will remain flashing or on as long as the indicated condition exists.
2
NIC2
Indicates network activity on LAN2 when flashing
1
NIC1
Indicates network activity on LAN1 when flashing.
HDD
Channel activity for the hard disk drives. This light indicates SATA drive activity on the