SUPER MICRO Computer 6015TC-10G, 6015TC-T manual Memory Support, Installing Memory Modules

SUPERSERVER 6015TC-T/6015TC-10G User's Manual

5-6 Installing Memory

!

CAUTION! Exercise extreme care when installing or removing DIMM modules to prevent any possible damage.

Memory Support

The X7DCT/X7DCT-10G has six 240-pin DIMM slots that can support up to 48 GB of registered ECC DDR2-667/533 SDRAM (for a total of 96 GB in the system).

The memory scheme is interleaved, so you must populate two slots at a time, beginning with slot 1A and 1B, then slots 2A and 2B, and finally into slots 3A and 3B if six DIMMs are to be installed. See table below.

Installing Memory Modules

1.Insert each memory module vertically, beginning with slots 1A and 1B (see above). Pay attention to the notches along the bottom of the module to pre- vent inserting it incorrectly.

2.Gently press down on the DIMM module until it snaps into place in the slot (see Figure 5-3).

3.Repeat to install a total of four or six DIMMs.

Optimized DIMM Configurations

No. of		Channel 0			Channel 1
DIMMs
2	DIMM1A	------	------	DIMM1B	------	------
4	DIMM1A	DIMM2A	------	DIMM1B	DIMM2B	------
6	DIMM1A	DIMM2A	DIMM3A	DIMM1B	DIMM2B	DIMM3B

Notes: i. DIMM slot# specified = DIMM slot to be populated; “---“ = DIMM slot not to be populated. ii. Both 533 MHz and 667MHz memory is supported; however, you need to use modules of the same speed and type. iii. For memory to work properly, you need to follow the restrictions listed above.

Figure 5-3. DIMM Installation

Notch		Notch
Release	Note: Notch	Release
Tab		Tab
	should align
	with its
	receptive point
	on the slot

To Install: Insert module vertically and press down until it snaps into place. Pay attention to the bottom

notches.

To Remove: Use your thumbs to gently push each release tab outward to free the DIMM from the slot.

5-8