SUPER MICRO Computer 6015TC-T, 6015TC-10G Power Supply Failure, Replacing the Power Supply

Chapter 6: Advanced Chassis Setup

6-5 Power Supply

The SuperServer 6015TC-T/6015TC-10G has a single 780 watt power supply. This power supply has the capability of operating at 100 - 240 input volts. Depress both main power buttons on the front of the chassis and then unplug the AC power cord to completely remove power from the system before removing the power supply.

Power Supply Failure

If the power supply unit fails, the system will shut down and you will need to replace the power supply unit. Replacement units can be ordered directly from Supermicro (PWS-781-1S - see contact information in Chapter 1).

Replacing the Power Supply

Accessing the Inside of the System

1.Grasp the two handles on either side and pull the unit straight out until it locks (you will hear a "click").

2.The top cover of the chassis is secured with four screws: two at the top rear of the cover and one on each side lip, also near the back. Remove all four, then place both thumbs in the indentations and push the cover back until it slides off.

3.Lift the top cover from the chassis to gain full access to the inside of the server.

Removing the Power Supply

1.First unplug the power cord from the system.

2.To remove the failed power unit, remove the two screws on the back of the power supply, which secure it to the chassis.

3.Lift the unit straight out of the chassis. (See Figure 6-5.)

Installing a New Power Supply

1.Replace the failed unit with the exact same power supply model from Supermicro.

2.Carefully insert the new unit into position in the chassis and secure it with the two screws at the rear of the unit.

6-5