SUPER MICRO Computer AS1021M-T2 Floppy, IDE, Sata and Scsi Drive Connections, Floppy Connector

Chapter 5: Advanced Serverboard Setup

5-11 Floppy, IDE, SATA and SCSI Drive Connections

Use the following information to connect the fl oppy and hard disk drive cables.

The fl oppy disk drive cable has seven twisted wires.

A red mark on a wire typically designates the location of pin 1.

A single fl oppy disk drive ribbon cable has 34 wires and two connectors to provide for two fl oppy disk drives. The connector with twisted wires always connects to drive A, and the connector that does not have twisted wires always connects to drive B.

The 80-wire ATA133 IDE hard disk drive cable that came with your system has two connectors to support two drives. This special cable should be used to take advantage of the speed this new technology offers. The blue connector connects to the onboard IDE connector interface and the other connector(s) to your hard drive(s). Consult the documentation that came with your disk drive for details on actual jumper locations and settings for the hard disk drive.

Floppy Connector

The fl oppy connector is located

Floppy Drive Connector Pin Definitions (JFDD1)

beside the JIDE1 connector. See the table on the right for pin defi nitions.

Pin# Defi nition

1GND

3GND

5Key

7GND

9GND

11 GND

13 GND

15 GND

17 GND

19GND

21GND

23GND

25GND

27GND

29GND

31GND

33GND

Pin # Defi nition

2FDHDIN

4Reserved

6FDEDIN

8Index-

10Motor Enable

12Drive Select B-

14Drive Select A-

16Motor Enable

18 DIR-

20 STEP-

22Write Data-

24Write Gate-

26Track 00-

28Write Protect-

30Read Data-

32Side 1 Select-

34Diskette

5-25