![](/images/new-backgrounds/1247219/247219113x1.webp)
Chapter 5: Advanced Serverboard Setup
Compact Flash Master/
Slave
The JCF1 jumper allows you to as- sign either master or slave status to a compact fl ash card populating the JIDE1 slot . See the table on the right for jumper settings.
Compact Flash
Master/Slave
Jumper Settings (JCF1)
Jumper Setting | Defi nition | |
Closed | Master | |
Open | Slave | |
|
|
SCSI Controller Enable/ Disable (H8DMR-82 only)
Jumper JPA1 is used to enable or dis- able the onboard SCSI controller. The default setting is on pins
defi nitions.
SCSI Enable/Disable
Jumper Settings (JPA1)
Jumper Setting Defi nition
Pins | Enabled | |
Pins | Disabled | |
|
|
SCSI Termination Enable/ Disable (H8DMR-82 only)
Jumpers JPA2 and JPA3 are used to enable or disable termination for the SCSI Channel A and B connector, re- spectively. The default setting is open to enable termination. See the table on right for pin defi nitions.
Note: In order for the SCSI drives to function properly, please do not change the default setting (enabled) set by the
manufacturer.)
SCSI Term. Enable/Disable
Jumper Settings (JPA2, JPA3)
Jumper Setting | Defi nition | |
Open | Enabled | |
Closed | Disabled | |
|
|