X7DA3+ User's Manual
Notes:
1.Before adding a new drive to an array, back up any data contained on the new drive to prevent data loss.
2.If you stop the Build or Clear process on a RAID 1 from Array Confi guration Utility, you can restart it by pressing Ctrl+R.
3.If you have used Quick Init to create a RAID 1, you might fi nd some data incompat- ible after running a consistency check. This is normal.
4.You can use drives of different sizes in a RAID. However, during a build process, only the smaller drive can be selected as the source or fi rst drive.
5.When migrating from single volume to RAID 0, migrating from a larger drive to a smaller drive is allowed. However, the destination drive must be at least half the capacity of the source drive.
6.It is not recommended that you migrate or build an array on Windows dynamic disks (volumes), as it will result in data loss.
Warning: Do not interrupt the creation of a RAID 0 using the Migrate option. If you do, you will not be able to restart, or to recover the data that was on the source drive.
