SUPER MICRO Computer MIIC-203 manual Interrupt Signal Control/Status, Open I2C Connection

//	Status Display
/B[012]	RS-232 Baud Rate Control (0=19.2, 1=57.6, 2=115.2KHz)
/C	Close I2C Connection
/Dxx	Set Destination I2C Slave Address
/E[01]	Echo/Prompt Control (0=Disable, 1=Enable)
/F[01]	Flow Control (0=XON/XOFF, 1=RTS/CTS)
/G[01]	General Call Control (0=Disable, 1=Enable)
/H[01]	Hex Only Display Control (0=Disable, 1=Enable)
/Ixx Set	iPort/AFM’s Own I2C Slave Address
/K[0123]	I2C Bus Clock Rate Control (0=23, 1=86, 2=100, 3=400 KHz)
/M	Menu Display
/N([01AR])	iNterrupt Signal Monitor/Control/Status
	(0=Disable, 1=Enable / A=Assert, R=Release / <CR>=Status
/O	Open I2C Connection
/(*)Rn	Master Rx Message *=No Stop
/S(text)	Slave Tx Message
/(*)T(text)	Master Tx Message *=No Stop
/Un	Set I2C Bus Time-oUt in msec 0=Disable)
/V	Display Firmware Version (Major XX.XX Minor)
/X[...]...	Extended Cmds (See Prompt or User’s Guide)
/Y	Display Tx bYte Count

Interrupt Signal Control/Status

___

The INT signal allows the iPort/AFM to participate in INT master and/or slave communications.

Command: /N0[CR]	Disable Monitor
/N1[CR]	Enable Monitor
/NA[CR]	Assert INT Signal
/NR[CR]	Release INT Signal
Response: *
Default Setting: /N0, /NR

Open I2C Connection

This command activates iPort/AFM as an active device on the I2C Bus.

Command: /O[CR]	'Open I2C Connection
Response: /OCC[CR]	'Open Connection Complete
Default Setting:	Closed

38