![AUTOMATIC ROOM CORRECTION](/images/new-backgrounds/25483/2548323x1.webp)
AUTOMATIC ROOM CORRECTION
The automatic room correction feature is designed to perform the entire room cor- rection process without using a PC interface. The
CAUTION
from the 2.2 XP front panel
PC based room correction requires that the 2.2 XP is connected to the RS232 port of a PC. PC software is used just as a GUI (graphical user interface) to provide the user with a graphical presentation of the correction process. After the room response measurement is completed, the room frequency response for all mea- sured channels can be displayed on the screen. Crossover fi lters and actual cor- rection fi lters can be viewed. The displayed graphs provide valuable information that helps users design their own optimum target curve.
The
When the 2.2 XP is connected to a PC and the automatic feature is enabled, au- tomatically generated target curves will be uploaded into the RCS/DRC screen. The curves can than be saved or modifi ed. Modifi ed curves can than be loaded back into the 2.2 XP. However, the uploaded curves will not take effect until the automatic feature is disabled. Any target curve uploaded to 2.2 XP is saved as a PC generated target curve and takes effect only when the automatic feature is disabled. In another words, if a target curve is to be modifi ed by the PC software, the automatic correction feature has to be disabled.
This following describes the automatic room correction process for all 2.2 XP operating modes.
12Tact Audio