TacT Audio RCS 2.2 XP owner manual AMP menu

Front Panel > Main Menu

AMP menu	The AMP menu is designed to allow the RCS 2.2 XP to interface with the TacT
	line of digital amplifiers. The RCS 2.2 XP can control multiple digital amplifiers.
	This setting should be ENABLED only if you have a Tact digital amplifier
	attached to the RCS 2.2 XP.

To change the settings use the “UP” and “DOWN ” navigational buttons to high- light the option and then press the “ENTER” button to change the setting.

If the L & R option is set to DISA BLE, th e Left/Right channel will operate in normal mode. The mater level control will affect both the digital and the ana log output signal.

If the L & R option is set to ENABLE, the master level control has no effect on the Left/Right analot or digital output signal. The Left and Right channel signal will output the maximum signal level, which is equivalent to the 99.9 setting on the volume display. The front panel master level information (relative read out, 0-99.9) will be broadcast to all digital amplifiers connected to the RS232 AUX connector. In this case, volume control is implemented in Tact digital amplifiers.

The same applys to th e SUB L & R option.

For example, one amplifier can be used for main left and right channels and the second one can be used for the left and right subwoofer channels. If two TacT digital amplifiers are connected, both options should be set to ENABLED. If one Tact digital amplifier is connected only one option should be set to ENABLED and the other one should be set to DISABLED. Enable should only be set for the output that uses Tact digital amplifiers.

NOTE: When a TacT digital amplifier is controlled by the RCS 2.2 XP, all of the amplifier’s front panel and IR controls are disabled. Use the RS232 port and/or daisy chain to link the components.

CAUTION: The AMP setting should only be set to ENABLED if you have Tact amplifiers connected to the RCS 2.2 XP. When the AMP option set to ENABLED both the analog and the digital output will output a full level sig- nal regardless of the RCS 2.2 XP master volume setting. If you do not have Tact amplifiers connected to your system you will not be able to control the output level from the RCS 2.2 XP volume control. The output is sent at its maximum level and can result in damage to your speakers.

Tact Audio 37