TANDBERG GWDataport Command Interface User Guide
| Example of ipqos feedback: |
| *P ipqos prectlph audio auto |
| *P ipqos diffstlph audio 0 |
| *P ipqos precvtlph audio auto |
| *P ipqos precvtlph signalling auto |
| *P ipqos precvtlph video auto |
| *P ipqos precvtlph data auto |
| *P ipqos diffsvtlph audio 0 |
| *P ipqos diffsvtlph signalling 0 |
| *P ipqos diffsvtlph video 0 |
| *P ipqos diffsvtlph data 0 |
| *P ipqos mode precedence |
| *P ipqos tos off |
| *P ipqos rsvp off |
|
|
isdnprot | Defines various ISDN protocol settings. |
| isdnprot nsftel <number> |
| or |
| isdnprot nsfvid <number> |
| or |
| isdnprot sendcomplete <on/off> |
| or |
| isdnprot restart <on/off> |
| or |
| isdnprot alert <on/off> |
| or |
| isdnprot hlc <on/off> |
|
•nsftel / nsfvid: Selects Network Service Facility for videophony or telephony on
•sendcomplete: The Q.931 message "Sending complete" can be turned off. This is only applicable for some Australian switches, which stop outgoing calls when the message “send complete” is sent to the switch.
•restart: When restart is set to on the PRI interfaces will be reinitialized after boot.
•alert: If set to on, the system will respond with an alert message to all incoming setup messages. If set to off, the system will respond with an alert message only to the incoming setup message related to the initial channel.
•hlc: Turns sending of HLC information element in setup message on or off (video calls only).
|
| Example of isdnprot feedback: |
|
|
| *P isdnprot nsftel "" |
|
|
| *P isdnprot nsfvid "" |
|
|
| *P isdnprot sendcomplete off |
|
|
| *P isdnprot restart on |
|
|
| *P isdnprot alert on |
|
|
| *P isdnprot hlct on |
|
|
|
|
|
| netprofile | Network profiles are used to predefine a set of call prefixes to be used by directory |
|
|
| entries. |
|
|
| netprofile <profile number> <call prefix> [profile name] [network] |
|
|
|
|
|
| D13202 Rev 01 | 12 |
|
