TANDBERG D13202 manual sendnum on/off, snmp cn community name, snmp sc system contact name

TANDBERG GWDataport Command Interface User Guide

	*P services http on
	*P services https on
	*P services snmp on
	*P services ftp on
sendnum	Enables/disables broadcast of the local unit’s number during H.320 call setup.
	NOTE! The transfer of the local number to a remote system or the prevention
	thereof is dependent on the feature set supported by the network or networks
	between the GW and the endpoint.
	sendnum <on/off>
	---
	Example of sendnum feedback:
	*P sendnum on
snmp	Configures the snmp mib.
	Note! For more information about SNMP please read the TANDBERG SNMP
	application note.
	snmp cn <community name>
	or
	snmp sc <system contact name>
	or
	snmp sl <system location name>
	or
	snmp hi <host ip address.> [host ip address] [host ip address]
	---
	parameters:
	• community name: Textstring of maximum 16 characters.
	• system contact name: Textstring of maximum 50 characters
	• system location name: Textstring of maximum 50 characters
	• host ip address: ip address
	sub-commands:
	• cn: Used to set the community name parameter.
	• sc: Used to set the system contact name parameter.
	• sl: Used to set the system location name parameter.
	• hi: Used to set the host ip address parameters.
	Example of snmp feedback:
	*P snmp hi 10.0.2.255 "" ""
	*P snmp sl ""
	*P snmp sc TANDBERG
	*P snmp cn public
sport	This command is used to configure the serial port by setting baudrate, parity,
	databits and stopbits.
	sport [baudrate] [parity] [databits] [stopbits]
	---
	parameters:
	•	baudrate: 1200/2400/4800/9600/19200/38400/57600/115200
	•	parity: n/o/e
	•	databits: 7/8
	•	stopbits: 1/2
D13202 Rev 01		16