TANDBERG GW | Dataport Command Interface User Guide |
case where the user is trying to transfer a call from an inactive GW port (the user input is shown in bold).
calltransfer 1 999999
*R Invalid gateway id
ERROR
Parameter Setting Commands are commands that set a system parameter to a specific value. E.g.: The command ippassword sets the valid password needed to establish an IP connection with the GW to a specific value.
If the command is syntactically correct the GW returns OK, otherwise the GW returns ERROR. If *P parameter feedback is activated (ref. command feedback), and the parameter is successfully changed, the GW will return the command with the new value. An example of *P parameter feedback is shown below (the user input is shown in bold).
pardial on
OK
*P pardial on
When issuing a Parameter Setting Command with no parameter, the GW will return the command with the current setting. E.g.:
pardial
*P pardial on
OK
Status Commands are commands that list different sets of system parameters. If *S status feedback is activated (ref. command feedback), status commands are automatically called when corresponding parameters are being changed.
4.2.The commands
The commands are divided into five groups: System Configuration Commands, General GW Commands, System Status Commands, Debug Commands and Special Commands.
D13202 Rev 01 | 8 |