TANDBERG D13202 manual System Configuration Commands

TANDBERG GWDataport Command Interface User Guide

4.2.1. System Configuration Commands

Command:	Description:
defvalues set	This command is used to restore factory default settings. Issuing this command with
	no parameters will restore all settings except network settings and option key.
	To reset all values to factory defaults the optional parameter all or *factory should
	be added. Please download the parameter file, or write down the optionkey before
	you execute this command (issue the command optionkey to view the current value
	of the optionkey).
	defvalues set [all/factory]
	* Adding the optional parameter factory, the eeprom will be erased and the flash
	disk will be formated.
h323gatekeeper	Sets gatekeeper parameters.
	NOTE! H.323 services must be set before the GW can be registered to a gatekeeper,
	ref. command gwh323service.
	h323gatekeeper <on/off>
	or
	h323gatekeeper address <ipaddress>
	---
	sub-commands:
	•	address: Sets the IP address of the gatekeeper
	Example of h323gatekeeper feedback:
	*P h323gatekeeper on
	*P h323gatekeeper address 10.0.0.30
ipaddress	Configures the LAN interfaces when static IP address allocation is used (the
	command ipassignment is used to select between DHCP and static IP address
	allocation).
	NOTE! The GW needs to reboot before the changes will apply.
	ipaddress [LAN interface] static <ipaddress>
	or
	ipaddress [LAN interface] subnetmask <ipaddress>
	or
	ipaddress [LAN interface] gateway <ipaddress>
	---

parameters:

•LAN interface: 1. Number identifying the LAN interface. If this parameter is omitted the command applies to all interfaces (only interface 1 is in use).

sub-commands:

•static: Sets the static IP address for the given LAN interface.

•subnetmask: Sets the subnet mask variable for the given LAN interface. Subnet mask defines the network class. If the setting is 255.255.255.0 the local network will support up to 256 nodes, denoting a class C network. If the setting is 255.255.0.0 the local network is a class B network with 65536 addressable nodes.

•gateway: Sets the gateway IP address for the given LAN interface. If a gateway is located on the LAN and the GW needs to reach nodes through this gateway, the gateway address can be set using the gateway variable (the IP address of the gateway will be set automatically if the GW is in DHCP mode)

D13202 Rev 01 9