Health Care System III | Installation |
Cart Adjustments
Triple-pivot Arm Counterbalance Adjustment
The following procedure applies to the optional LCD display mounting arm and the optional mobile camera cart arm.
A nitrogen gas spring is used to counterbalance the weight of the LCD display (or camera). To adjust the weight capacity of the arm, proceed as follows:
1)Remove the oval cap by prying it off with your thumbnail.
2)Position the arm at 90 degrees with respect to the cart post.
For adjustment purposes, a 3/16” hex wrench is stored in a clip behind the monitor’s tilt/swivel mechanism.
3)Take the 3/16” hex wrench and insert it into the hole. Turn the screw clockwise to decrease or counterclockwise to increase the weight capacity.
Oval cap
4)Remove the hex wrench and check the arm movement. Repeat the procedure if further adjustment is necessary.
5)When adjustment is complete,
Monitor Suspension Arm Adjustment
To adjust the suspension arm’s counterbalance, proceed as follows:
1) Lift the monitor to its uppermost position.
The counterbalance adjustment screw is accessed from the under side of the suspension arm near the monitor mounting bracket.
For adjustment purposes, a 3/16” hex wrench is stored in a clip behind the monitor’s tilt/swivel mechanism.
2)Take the 3/16” hex wrench and insert it into the access hole. Turn the screw clockwise to increase or counterclockwise to decrease the counterbalance.
3)Remove the wrench and check the arm movement. Repeat the procedure if further adjustment is necessary.
4)When finished, return the wrench to its storage clip behind the monitor’s tilt/swivel mechanism.
27
