TANDBERG D50104-15 user manual VNC Settings, Address, Display Number, Password, Start using VNC

Health Care System III Advanced Use

VNC Settings

NOTE

VNC SERVER SOFTWARE SETUP

•BOTH THE PC AND THE VIDEOCONFERENCING SYSTEM MUST BE CONNECTED TO THE LAN.

•A VNC SERVER MUST BE INSTALLED ON THE PC. FREE SOFTWARE CAN BE DOWNLOADED FROM HTTP://WWW.UK.RESEARCH.ATT.COM/VNC

•INSTALL THE SOFTWARE BY RUNNING THE DOWNLOADED FILE.

•TO CONFIGURE THE VNC SERVER SOFTWARE :

•SELECT “ACCEPT SOCKET CONNECTIONS”.

•SELECT “AUTO” FOR “DISPLAY NUMBER”. ‘DISPLAY NUMBER’ IN THE SYSTEM MUST THEN HAVE THE VALUE 0.

•ENTER A PASSWORD IN THE “PASSWORD”-FIELD. MUST CORRESPOND WITH THE ‘VNC SETTINGS’ ON YOUR SYSTEM.

Address

The IP-address of the PC with the VNC software installed. To find the IP-address of the PC, select ‘Command Prompt’ from the Startup-menu. Type ‘ipconfig’ and press ENTER.

Display Number

The display number for VNC is 0 and upwards. If you are using WinVNC, double-click on the icon on the toolbar to view ‘WinVNC properties’. This number should correspond with ‘Display Number’ in this menu.

Password

Enter the same password as specified in WinVNC properties. The password will be shown as asterisk signs

(*) the next time you enter the menu.

Start using VNC

To activate VNC, press ‘PC’ on the remote control. Please make sure that ‘PC’ is set to ‘VNC’ in the ‘Video Settings Menu’. See also ‘PC SoftPresenter’ section for further information.

71