Tandberg Data FS-1600, FS-1610 Sufficient Ventilation, Dummy Drive Drive Tray Release Button

Tandberg DataSetting Up

_____________________________________________________________

2.1.9.Sufficient Ventilation

The vents on the front panel and the fan openings on the rear panel provide ventilation for the FS-1600 Series NAS appliance. Make sure that these openings are not blocked and that adequate ventilation is provided where the unit is installed.

2.2.Accessing the HDD Tray & Installing Hard Drives

To install HDD to the FS-1600 Series NAS appliance, remove the drive tray from the chassis in order to mount any Serial-ATA I or II HDD.

1.Press the release tab to release the drive tray from its locking position.

2.Pull the drive tray out from the chassis by:

a.Pressing the tray handle release button.

b.Grab the tray handle and pull out the drive tray from the chassis.

3.Remove the 2 screws at each side of the dummy tray and take out the dummy tray as shown below:

Dummy Drive

Drive Tray

Release Button

2-3 Tandberg Viking FS-1600 Series NAS Hardware User Manual