7 – CD and MD Playback—Time Search function

Time Search function

By specifying time from the start of a certain track, you can start playback from a specified point of a specified track.

Basic operation

1During stop, play or playback standby modes, use the number keys on the remote control to input the three-digit track number (such as 002 for track 2), then the desired elapsed time (***min **sec) from the start of that track.

Example: To specify 1 min 30 sec from the start of track 2, input “002 001 30”

NOTE

For MP3 discs, time cannot be specified within a track. However, if you input the three-digit track number, playback will begin from the start of that track.

During input, the counter in the display will flash.

Regardless of the time display mode, the time from the start of the specified track is displayed.

When the final digit is entered, the desired position is automatically located. During stop or playback modes, playback will begin from the desired point. During playback standby mode, at the desired point the unit will enter playback standby mode.

NOTE

If a point which does not exist is selected, setting opera- tion will be cancelled.

Operation variations

Even if the final second is not input, playback will begin from the selected point after pressing the PLAY key. Or, if you press the READY key, the unit will enter the playback standby mode at the selected point.

Track search

This is explained in the “Specifying by track num- ber” part of “Track selection” on page 25.

After inputting the three-digit track number, press the PLAY key to begin playback of that track, or the READY key to cue the track and enter playback standby mode.

Specifying to the minute

After inputting the three-digit track number and the number of minutes after the start of the track, press the PLAY key to begin playback of that track, or the READY key to cue the track and enter playback standby mode.

Example: To specify 1 min 00 sec from the start of track 2, input “002 001”

NOTE

Following the above example, if “0021” is input, the same position will be located.

Auto cue

When the auto cue function is turned on, when a track is selected, the point where sound begins (not where the track begins) on that track is located, and the unit enters playback standby mode. Then, when the PLAY key is pressed, playback begins at exactly that point.

Auto cue on/off and the sound start position detec- tion level can be set separately for CD and MD.

NOTE

modes, the Auto Cue function will only cue to the very beginning of the track.

NOTE

During the stop mode, to cue to the start of sound on track one, just press the READY key.

Turning the Auto Cue function on and off

Press the AUTO CUE key on the remote control to turn this function on and off.

Auto Cue functions only for MD tracks recorded in the ST mode. For MD tracks recorded in MONO, LP2 or LP4

You can also use the “A_CUE?” option on the PLAY sub-menu of the MD menu or CD menu to turn the

26 TASCAM MD-CD1 Owner’s Manual

Page 26
Image 26
Tascam MD-CD1 owner manual CD and MD Playback-Time Search function, Auto cue, Basic operation, Operation variations