Teka TRX 645, IQX 635 Fixing the hob, Connecting the electricity, Installation with a Thermoventi

Depending on the thickness of the worktop, it is possible to use the self-tapping screws that are provided as a fastening accessory by putting them into the clip's round hole. This hole will be threaded as the screw is inserted into it. This should be done before fixing the clip to the worktop.

GB

INSTALLATION WITH A THERMOVENTI-
		Fixing the hob
LATED OVEN UNDER THE HOB
The oven should be installed according to		When the gap has been properly sized,
the corresponding manual.		the gasket should be put on the lower side
		of the glass. Silicone should not be
If installing over a thermoventilated oven,		applied between the glass and the unit
please remember that this hob has been		worktop because if it becomes neces-
certified to work only with TEKA brand		sary to remove the hob from its posi-
ovens.		tion, the glass could break when trying
An opening of 20 mm should be made in		to detach it.
the back part of the kitchen unit so that		To fasten the cooking top to the kitchen
cold air is able to enter (see figure 1).		unit, use four clips fastened to the existing
		openings in the lower part of the body (two
	It is advisable not to use the	in front and two in back). There are two
induction hob during the pyrolitic clea-		possible ways to position the clips, as can
ning function in the case of the pyrolitic		be seen in figure 2.
ovens, due to the high temperature rea-
ched by this appliance.

When hobs are handled before being installed, care should be taken in case there is any protruding part or sharp edge which could cause injury.

When installing units or applian- ces above the hob, the hob should be protected by a board so that the glass cannot be damaged by accidental blows or heavy weight.

The glues used in manufacturing the kitchen unit and on the decorative laminates and on the laminates that are part of the worktop surface should be made to tolerate temperatures of up to 100ºC.

TEKA does not assume any res- ponsibility for any malfunction or damage caused by faulty installation.

fig. 2 Sealing washer

Sealing washer

Connecting the electricity

PLEASE REMEMBER THAT THE	GUA-	The electric connection is made using an
RANTEE DOES NOT COVER	THE	omnipolar switch or plug, where accessi-
GLASS IF IT SUFFERS A VIOLENT		ble, that is suitable for the intensity to be
BLOW OR IF IT IS USED IMPROPERLY.		tolerated and that has a minimum gap of 3

16