GB
11 Indicator symbol of the clock sensors zone.
12 Indicator of selected time (clock).
13 Indicator light of the induction element with timer.
14 Indicator symbol of the induction ele- ment with timer.
15 Keep Warm Function sensor button (models IRX... and IQX...).
16 Decimal point in power indicators.
-Shines (on): Chosen induction element (ready to be used).
-Doesn't shine (off): Induction element locked (cannot be used).
NOTE: * Only visible when appliance is operating.
Actions are carried out using the sensor buttons marked on the control panel.
It is not necessary put pressure on the glass; by simply touching the sensor but- ton with your finger you will activate the desired function.
The touch cursor can be used to adjust the power levels
It is also possible to directly select the des- ired value by touching the area of the touch cursor with your finger.
Each action is confirmed with a beep.
TURNING ON THE APPLIANCE
1 Touch the on sensor button 
(1) for at least one second.
The touch control panel is activated and a 0 appears on all the power indicators (3). The decimal point (16) flashes to indicate
that no cooking zone has been selected at that time. If a cooking zone is hot, the corresponding indicator will show an H and a 0 alternately.
In IRX... and IQX... models, if the Lock Function is activated, the indicators in the cooking zones will have an L. If there is a residual heat on the cooking zones, the corresponding indicator will have an L and an H alternately.
The next action must be taken within 20 seconds; otherwise, the touch control panel will automatically turn off. If you have chosen a heating element at a power level of 0 and you don't change the value, the heating element will no longer be selected after 10 seconds.
When the touch control panel is activated, it can be disconnected at any time by tou-
ching sensor 
(1), even if it has been locked (see the section "Locking the sen- sor buttons of the hob"). Sensor button
(1) is always able to disconnect the touch control panel.
ACTIVATING THE HEATING ELEMENTS
Once the touch control panel has been
activated by using sensor button 
(1), you can turn on the chosen heating ele- ments.
1 Choose the heating element by using the corresponding indicator (3), i.e. by using your finger to touch the digit. If the hea- ting element is hot, the corresponding indicator will go from showing H to level
0.
2 Use the slider cursor to choose the power level, from between 0 and 9. By doing so, the heating element will remain activated.
20
