Teledyne M200E and M400E Thermocouple Inputs and Configuration Jumper JP5, Type J Compensation

Addendum to E-Series Operator Manuals Relay PCA 04523

2.4.1. Thermocouple Inputs and Configuration Jumper (JP5)

Although the 04523 relay PCA supports two thermocouple inputs, the current M100E/M200E series analyzers only utilize one and the M400E series analyzers none. By default, this single thermocouple input is plugged into the TC1 input (J15). TC2 (J16) is currently not used. See Figure 1-1 for location of J15 and J16

Table 2-4: Thermocouple Configuration Jumper (JP5) Pin-Outs

TC INPUT	JUMPER PAIR	DESCRIPTION	FUNCTION
			Selects preamp gain factor for J or K TC
	1 – 11	Gain Selector	- IN = J TC gain factor
			- OUT = K TC gain factor
			Selects preamp gain factor for J or K TC
	2 – 12	Output Scale Selector	- IN = 5 mV / °C
			- OUT = 10 mV / °C
TC1			When present, sets Cold Junction
	3 – 13	Type J Compensation
			Compensation for J type Thermocouple
			When present, sets Cold Junction
	4 – 14	Type K Compensation
			Compensation for K type Thermocouple
			Selects between Isolated and grounded
	5 – 15	Termination Selector	TC
			- IN = Isolate TC
			- OUT = Grounded TC

TC2

6 – 16	Gain Selector
7 – 17	Output Scale Selector
8 – 18	Type J Compensation
9 – 19	Type K Compensation
10 – 20	Termination Selector

Same as Pins 1 – 11 above. Same as Pins 2 – 12 above. Same as Pins 3 – 13 above. Same as Pins 4 – 14 above. Same as Pins 5 – 15 above.

12 05118 Rev B3