Table 7. Set Config port parameters (continued)
Parameter | Description |
|
|
SymbolicPortName | Descriptive name |
|
|
ALFairness | Default is switch that has priority |
|
|
ARB_FF | Use ARB_FF instead of idles on loop FCAL option |
|
|
InteropCredit | Number of |
|
|
ExtCredit | Extended credit port |
|
|
FANEnable | Fabric Address Notification. If enabled, notifies |
| address, port name, and node name. |
|
|
LCFEnable | Link control frame preference, R_CTL = 0xC |
|
|
MFSEnable | |
|
|
MFS_TOV | MFS limit for camp on |
|
|
MSEnable | Management Server enable on this port |
|
|
NoClose | Do not close unless another device arbitrates |
|
|
I/O Stream Guard | Enables or disables the suppression of RSCN messages |
|
|
VIEnable | Not applicable |
|
|
CheckAlps | Close before sending frames to new target |
|
|
switch
Initiates an editing session in which to change switch configuration settings. Each parameter is displayed, one line at a time and prompts you for a value. For each parameter, type a new value or press the Enter key to accept the current value shown in brackets. Type q to cancel the configuration.
Table 8. Set Config switch parameters
Parameter | Description |
|
|
AdminState | Switch administrative state: online, offline, or diagnostics. |
|
|
Broadcast Enable | Enables (True) or disables (False) forwarding if broadcasting frames. |
|
|
InbandEnabled | Enables (True) or disables (False) the ability to manage the switch over an ISL. |
|
|
DefaultDomainID | Default domain ID setting. |
|
|
DomainIDLock | Prevents (True) or allows (False) dynamic reassignment of the domain ID. |
|
|
SymbolicName | Descriptive name |
|
|
R_T_TOV | Receiver Transmitter Timeout Value. Specifies the number of milliseconds a port |
| is to wait to receive a response from another port. The default is 100. |
|
|
R_A_TOV | Resource Allocation Timeout Value. The number of milliseconds the switch waits |
| to allow two ports to allocate enough resources to establish a link. The default is |
| 10000. |
|
|
E_D_TOV | Error Detect Timeout Value. The number of milliseconds a port is to wait for errors |
| to clear. The default is 2000 msec. |
|
|
FS_TOV | Fabric Stability Timeout Value. The default is 5000 msec. |
|
|
30Intel Blade Server Switch Module SBCEFCSW Management and User’s Guide