Intel SBCEFCSW manual Examples, System configuration settings

Table 12. System configuration settings

Entry	Description
Eth0NetworkAddress	Ethernet Internet protocol (IP) address
Eth0NetworkMask	Ethernet subnet mask address for the Ethernet port.
Eth0GatewayIPAddress	Ethernet IP address gateway
Eth0NetworkDiscovery	Ethernet boot method (1 - Static).
	Note: BootP, DHCP, and RARP do not apply
AdminTimeout	Specifies the amount of time in minutes the switch waits before terminating an
	idle Admin session. Zero (0) disables the time out threshold. The default is 30;
	the maximum is 1440.
Security Enabled	Enables or disables the enforcement of account names and passwords.
Remote Log Enabled	Whether remote logging is enabled or disabled. If enabled, log information is
	saved to a remote host that supports the syslog protocol.
RemoteLogHost IP Address	The IP address of the host that will receive the remote log information if
	remote logging is enabled.

✏NOTE

The two components of security are user authentication and fabric security. The user must be authenticated before gaining access to a switch. If an invalid account name/password combination is entered, that user can not access the switch, and thus cannot gain access to the fabric. If security is enabled (True) and a valid account name/password combination is entered, that user can access the switch but can not execute any command that exceeds their authority (privileges) level. If security is disabled (False) and a valid account name/password combination is entered, that user has access to all switches in the fabric and can execute all commands (both user and admin), regardless of their authority (privileges) level.

Examples

The following is an example of the Set Setup SNMP command.

FCSM: user1> admin start

FCSM (admin) : user1> set setup snmp

A list of attributes with formatting and current values will follow.

Enter	a new	value or	simply press the		ENTER key to accept		the	current value.
If you wish		to terminate		this process	before	reaching the	end	of the list
press	'q' or 'Q' and		the	ENTER key to	do so.

Trap Severity Options
---------------------
unknown, emergency,	alert, critical, error, warning, notify, info, debug, mark
Contact	(string, max=32 chars)	[<sysContact undefined> ]
Location	(string, max=32 chars)	[<sysLocation undefined>]
Trap1Address	(dot-notated IP Address)	[10.0.0.1	]
Trap1Port	(decimal value)	[162	]
Trap1Severity	(see allowed options above)	[warning	]
Trap1Enabled	(True / False)	[False	]

40Intel Blade Server Switch Module SBCEFCSW Management and User’s Guide