Argent Terminal Adaptor - User Guide
AT | Description |
|
|
| ATQ0 (default) Enable result codes output to the terminal. |
| ATQ1 Disables result codes to the terminal. |
| ATQ2 Disable result code in answer mode only. |
\Q | Flow Control |
| AT\Q0 disables flow control |
| AT\Q1 enables XON/XOFF software flow control |
| AT\Q3 (default) enables RTS/CTS hardware flow control |
%R | Read all S registers |
| AT%R Read all the S registers |
%S | Serial Number |
| AT%S Read the ATA serial number |
Sn? | Read S register value |
| eg ATS51? Retrieves the telephone number |
Sn= | Write S register value |
| eg ATS51=6173344 5566 |
\T | Idle Timeout |
| Time before the link will hang up the line if no data on the connection. |
| AT\T2 sets up the timer to hang up after 2 minutes idle time |
| AT\T0 disables the idle timer so it will not cause a hang up |
| Idle Timeout can be set in minutes with valid values of 0 to 255. |
VResult code format
ATV0 All results returned in short form ATV1 (default) results returned in long form
%V | ATA version number can only be read. |
| AT%V displays the version number of the software in the ATA |
&V | Display current configuration |
| Shows all the current parameters |
&W | Save current configuration |
| AT&W This will store the parameters even if the ATA is turned off |
ZReset
ATZ resets the ATA without changing the configuration. Current calls would be lost.
+++Enter Command Mode
+++ must be a half second of no data actvity before and after “+++”.
4.3S register settings
Register | Description |
|
|
S0 | Auto Answer number of rings |
| ATS0=0 (default) disables answering incoming data calls |
| ATS0=n where n is a value 0 to 255 rings |
S51 | ATA Telephone Number |
| ATS51=6173344 5566 store the phone number to present in calls. The |
| other party on the line will see this number as your number. This number |
| must be one of the numbers issued on this connection by Telstra. MSN |
Version 1.1 | Telstra Corporation Limited |
Page 22/29 | ACN 051 775 556 |
