Telstrat Argent manual Point-to-Point Protocol PPP Installation, Click on Control Panel

Argent Terminal Adaptor - User Guide

3.6.14 Point-to-Point Protocol (PPP) Installation

PPPis used to connect to Internet or other ISDN TAs using the common Windows, Unix, Macintosh interfaces. Most commonly, it is used for Internet access.

PPPover a OnRamp® 2 B-channel can be invoked via the V.24 Serial port, from a Windows 95 PC or similar, by setting up Dial-up networking similar to the configuration of a standard modem.

To use PPP, set up your computer as you would for connecting a standard modem - with no parity, 8 data bits and one stop bit, (ie N, 8,1).

The Argent Terminal adaptor connects to a terminal or computer with a standard modem cable. Plug the D25 male connector into the V.24 / RS232 Serial port on the ATA using a standard straight through modem cable.

Connecting communications equipment, like a modem or router, to the ATA’s V.24 port would require a crossover cable.

Follow the steps below to install the ATA as a Standard Modem

Check Braintree’s website (www.braintree.com.au) for the latest information on installation.

1.Click on START

2.Click on Settings

3.Click on Control Panel

4. Double Click on Modem

Version 1.1	Telstra Corporation Limited
Page 13/29	ACN 051 775 556