Argent Terminal Adaptor - User Guide
Only the decimal point on the Seven Segment Display is illuminated when the configuration has been downloaded successfully by the Argent NMS, and the ATA is functioning correctly with connected EFTPOS terminals responding normally. No other codes will be displayed on the Seven Segment Display in this mode and the unit can be assumed to be correctly configured and operational.
If the ATA is commissioned before it is connected to an EFTPOS machine then it will display a flashing 3 until the EFTPOS machine is connected.
3.6 ATA Activation Instructions
Telstra should supply the following information after the OnRamp® 2
∙Argent EFTPOS service FNN:
FNN = FxxxxxxxxxxY (Argent Dedicated Service) FxxxxxxxxxxT (Argent Test Service)
where xxxxxxxxxx is the 10 digit number of the OnRamp® 2 service.
∙TEI number
∙Whether this is a migration from Transend to Argent service.
The steps following can then be followed:
3.6.1Prepare position
The ATA can be installed either horizontally or vertically. Make sure that it is close to the OnRamp® 2 NT1 (2 metres) and a 240V outlet and within reach of the EFTPOS terminal. Avoid placing the unit in direct sunlight or near hot surfaces.
3.6.2Connect ATA to NT1
Connect the ATA ISDN Port to the OnRamp® 2 NT1
3.6.3Connect the EFTPOS terminal to ATA
Connect the cord from the EFTPOS terminal into the EFTPOS 611 connector on the ATA back panel. In some cases it may be possible to bypass an existing EFTPOS modem and go directly into the V.24 modem. Telstra will be able to advise if this is possible, and set up the ATA from the Management system to accommodate this connection.
Version 1.1 | Telstra Corporation Limited |
Page 9/29 | ACN 051 775 556 |
