Telstrat Argent manual Observe that the ATA is ready and record the service details

Argent Terminal Adaptor - User Guide

3.6.12 Observe that the ATA is ready and record the service details

When the above steps have completed successfully, and the configuration is downloaded. There may be a 1-2 minute delay while the ATA activates software, after which the decimal point on the Seven-Segment Display will be illuminated indicating that the unit is now ready for EFTPOS transactions. (NOTE: If the EFTPOS terminal is not yet connected the final display will be a flashing 3 - “No carrier from EFTPOS modem”). After observing this write the following information onto the sticker at the bottom of the unit:

∙Argent EFTPOS service FNN:

FNN = FxxxxxxxxxxY (Argent Dedicated Service) FxxxxxxxxxxT (Argent Test Service)

where xxxxxxxxxx is the 10 digit number of the OnRamp® 2 service.

∙TEI = xx

∙ATA Fault Reporting Number = Service Provider Helpdesk number

∙Date of Purchase = dd/mm/yy

You must call your own Help Desk fault reporting number for any difficulties. This number is supplied with the EFTPOS terminal.

3.6.13 Replace the ATA if Faulty on Arrival

If the ATA is faulty on arrival, see section 3.8 for warranty instructions.

Version 1.1	Telstra Corporation Limited
Page 12/29	ACN 051 775 556