Set Up Your SX7, Tip | Telular SX7M, SX7T guide

Getting Started

Set Up Your SX7

1.Install the SIM Card into the SIM card holder in the battery compartment.

If applicable, remove the SIM Card from the larger plastic card holding it.

Remove the battery compartment door from your SX7 unit.

Carefully slide the SIM Card into the SIM card holder inside the battery compartment. It will slide lengthwise as shown below, with the gold contact surface facing into the SX7 and the corner notch matching the plastic SIM holder outline.

Note

Do not touch the gold-coloredareasof yourSIMCard.

Battery
Compartment	SIM Card
(open)	(installed) Battery Terminal

Battery

Connector

Rechargeable

Battery Pack

2.Install the Rechargeable Battery Pack into the battery compartment.

With the battery compartment door open, insert the battery connector into the battery terminal.

Tip

The battery connectorwillhavethe roundedcornersideon theleft when inserted intothe batteryterminal.

Arrange the battery pack in the battery compartment, so the battery connector wire is in the top right of the compartment.

Replace the battery compartment door.

Wi PATHTM SX7

2

User Guide

Image 4

Telular SX7M, SX7T manual Set Up Your SX7, Tip

Contents

Wi Pathtm SX7T Terminal and SX7M Modem User Guide Table of Contents Introduction Getting Started With the Wi Pathtm SX7YourWi PATHSX7 Components USB Cable a to B not pictured RJ-11 Phone Cable Set Up Your SX7 Tip To power outlet Ground Connector Screw Power Up the SX7 Connect the SX7 to Your Computer Using the Telular Device Manager Connect to the Telular Device Manager Telular Device Manager Overview Setting Up YourWireless WAN Data Connection For PSD Auto Connect, click Always On Data ConnectionThe Basics Status LEDs LED Reference Table Using the USB Connection Option Install the USB Drivers Set Up a Dial-Up Networking DUN Connection Connect the SX7 to Your Computer With a USB Cable USB Connection Option USB Connection Option Using the Voice and Fax Options SX7T Only Using the Voice Calling Features on Your SX7T Using the Fax Function on Your SX7T For MT Call Type 3 select FAX Next Call or FAX Always Phone/Fax Pstn Settings Voice/Fax Programming Basic Pots Setup Setup Options Setup LANLAN Features Advanced Data Connection Options Setup Wireless WAN Dhcp Settings Setup Keep Alive Setup Ddns Setup SIM Network Routing Network OptionsRouter NAT off RIP Version Select v1 or v2 default Network Firewall/Filters Network Port Forwarding Network DMZ Administration Options Admin Management Admin Factory Defaults Admin Firmware Upgrade Status Options Status Router Status LAN Ethernet Status Status LAN USB Status Wireless WAN Status Pstn Options Pstn Basic Pstn Call Control Pstn Pots Setup Configuring TCP/IP Settings Advanced SettingsWindows XP Glossary Line Ring WiPATH SX7 Rear Panel View and Connectors SX7 Connections An Overview