288 Appendix A: Function and Instruction Reference
73A-ENG.DOC AppxA: Function/Instruction Reference, English Julie Hewlett Revised: 07/29/98 1:10 PM Printed:
05/19/99 9:03 AM Page 288 of 36
DispTable
8I/O
Programming command (display table); displays the
table for all defined and selected Yn functions during
program execution.
PROGRAM:TABLE
:"2X+5"ÜY
:IndpntAuto
:DependAuto
:DispTable
angle8DMS
-uANGLE
Converts an angle to DMS (degrees¡ minutes'
seconds") notation. Results are determined by the
Angle mode setting (Radian or Degree).
In Degree or Radian mode:
50¡8DMS b50¡0'0"
In Radian mode:
50 8DMS b
2864¡47'20.312"
:DS<(variable,value)
:command1 (if answer | value)
:command2
8CTL
Programming command (decrement and skip if less
than); subtracts 1 from variable. If the answer is <
value, then command1 is skipped; if the answer is |
value, then command1 is executed. command2 is
always executed.
PROGRAM:DS
:9ÜA
:Lbl S
:Disp A
:DS<(A,5)
:Goto S
:Disp "A IS NOW <5"
:Pause
e^(x)
1LOG
Raises e to a power of x, where x is a real number, an
expression that results in an real number, or a list of
real numbers. e equals 2.71828182846.
e^(2.5) b12.18249396
value © exponent
-{
Enters a number in scientific notation. The display of
the result depends upon the Numeric mode setting
(Normal or Sci). value can be a real number or list.
In Normal Numeric mode:
12.3456789©5
b1234567.89
(1.78/2.34)©2
b
76.06837607
{6.34,854.6}©3
b
{6340 854600}
Else
See If:Then:Else:End
End
8CTL
Programming command; you must include an End
instruction at the end of each For(, While, or Repeat
loop. Also, you must enter an End instruction at the
end of each If–Then group and each If–Then–Else
group.