Typical Setup Procedure
From the Web Administration Interface, you can begin to setup your M3800 for use on your network. Setting up the M3800 typically follows the five steps outlined below.
For more on how to use the Web Administration Interface, see Chapter 4: System Management > Web Administration Interface.
Step 1: Network Setup
From the Web Administration Interface, you can configure the network settings of the M3800 for your network. You can access the Network menu from the menu bar.
For details on how to configure your network settings, refer to Chapter 4: System Management > Network Management.
Step 2: RAID Creation
Next, administrators can configure their preferred RAID setting and build their RAID volume. You can access RAID settings from the menu bar of the Web Administration Interface by navigating to Storage > RAID.
For more information on configuring RAID, see Chapter 4: System Management > RAID Configuration.
Don’t know which RAID level to use? Find out more about the different RAID levels from Appendix C: RAID Basics.
Step 3: Create Local Users or Setup Authentication
Once the RAID is ready, you can begin to create local users for the M3800, or choose to setup authentication protocols such as Active Directory (AD).
For more on managing users, go to Chapter 4: System Management > User and Group Management.
For more information on configuring Active Directory, see Chapter 4: System Management > User and Group Management > ADS/NT Configuration.
For information about the benefits of Active Directory, see Appendix D: Active Directory Basics.
Step 4: Create Folders and Set Up ACLs
Once users are introduced into your network, you can begin to create various folders on the M3800 and control user access to each using Folder Access Control Lists.
More information on managing folders, see Chapter 4: System Management > Folder Management.
To find out about configuring Folder Access Control Lists, see Chapter 4: System Management > Folder Management > Folder Access Control List (ACL).
19
