Chapter 1 PREPARATIONS

Turning Power ON/OFF

This section explains how to turn the power ON and OFF as well as the energy saving mode. How to turn the power ON differs between when the MAIN POWER lamp (green) on the control panel is lit and when it is not.

Turning the power ON

When the MAIN POWER lamp (green) on the control panel does not light:

Turn the power ON there.

When the MAIN POWER lamp (green) on the control panel lights:

The equipment starts warming-up. “Wait Warming Up” appears during warming-up.

• While the equipment is warming up, you can use the auto job start function. For details, refer to the following guide:

&Copying Guide (PDF): “Chapter 2: HOW TO MAKE COPIES” - “Making Copies”

Press the [POWER] button.

When the equipment is ready for copying, “READY” will appear.

When you turn the power of the equipment OFF, be sure also to shut it down by pressing the [POWER] button on the control panel. Do not simply turn the main power switch OFF. For details, see the following page:

&P.13 “Turning the power OFF (Shutdown)” in this manual

When “ERASING DATA” appears

This message appears when the Data Overwrite Enabler has been installed. It appears immediately after the power is turned ON or after the equipment has been operated. You can operate the equipment even if it is displayed.

When the equipment is controlled under the department or user management function, enter the department code or user information first. For details, see the following page:

&P.67 “Logging in” in this manual

12

Page 14
Image 14
Toshiba 2050c Turning Power ON/OFF, Turning the power on, When the Main Power lamp green on the control panel lights