Placing Paper and Originals
Placing Paper and Originals
This section explains how to set paper and originals. Incorrect setting causes image skews or paper misfeeds. Follow the procedure below.
Placing paper
1 |
2 |
1
Pull out the drawer, and press down the paper plate. When placing paper in the Paper Feed Unit, Paper Feed Pedestal, or Additional Drawer Module, pull out the drawer, and then proceed to step 2.
2
Place paper face up.
3 
1
2 |
Set the end guide so that it matches the paper size.
4 | 1 |
1 
2
Set the side guides so that they match the paper size.
5 |
Push in the drawer.
Be careful not to catch your fingers when pushing the drawer back.
This could injure you.
Be sure that the height of the stacked paper does not exceed the MAX line indicated on the side guides.
•For paper available for the equipment, see the following page:
&P.70 “Specifications of Equipment” in this manual
•Paper can be placed in the Paper Feed Unit, Paper Feed Pedestal and Additional Drawer Module following the above procedure. For placing paper in the Large Capacity Feeder, refer to the following guide:
&Copying Guide (PDF): “Chapter 1: BEFORE USING EQUIPMENT” - “Placing Paper”
15
