Toshiba 42HPX95 owner manual Connecting a digital audio system, Connecting an analog audio system

Chapter 2: Connecting your TV

Connecting a digital audio system

The TV’s DIGITAL AUDIO OUT terminal outputs a Dolby*

Digital or 2-channel down-mixed PCM (pulse-code modulation) signal for use with an external Dolby Digital decoder or other external audio system with optical audio input.

You will need:

￿one optical audio cable (Use an optical audio cable that has the larger “TosLink” connector and not the smaller “mini-optical” connector.)

To control the audio:

Turn on the TV and the digital audio device.

Press MENU on the TV’s remote control and open the AUDIO menu.

Highlight Audio Setup and press ENTER.

In the Optical Output Format field, select either Dolby Digital
or PCM, depending on your
device (see “Selecting the
optical audio output format”				Audio
on page 93).				Audio Settings
				Advanced Audio Settings
				Audio Setup
	Audio Setup
		MTS				Stereo
		Language				English
		Speakers				On
		Optical Output Format			Dolby Digital
			Reset		Done

Turn off the TV’s built-in speakers in the same Audio Setup menu (above). Also see “Turning off the built-in speakers” on page 93.

Dolby Digital decoder or other digital audio system

LINE IN		Optical
L	R	Audio IN

TV back panel

Note:

¥Some audio systems may not be compatible with Dolby Digital bitstream signals. Older audio systems that are not compatible with standard optical out signals may not work properly, creating a high noise level that may damage speakers or headphones. THIS DAMAGE IS NOT COVERED BY YOUR WARRANTY.

¥The DIGITAL AUDIO OUT terminal outputs signals only when receiving digital broadcasts with the TV in single-window mode.

¥The DIGITAL AUDIO OUT terminal may not output some digital audio sources because of copy restrictions.

*Manufactured under license from Dolby Laboratories.

ÒDolbyÓ, ÒPro LogicÓ and the double-D symbol are trademarks of Dolby Laboratories.

Connecting an analog audio system

This connection allows you to use external speakers with an external audio amplifier to adjust the sound level.

You will need:

￿one pair of standard audio cables

To control the audio:

Turn on the TV and the stereo amplifier.

Turn off the TV’s built-in speakers (see “Turning off the built-in speakers” on page 93).

Note: To hear sound when using an external audio amplifier, the volume of both the TV and the amplifier must be set to a reasonable listening level.

Analog audio amplifier

LINE IN

L R

TV back panel

24		Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
#01E_014-030_4250HPX95	24	05.9.12, 10:17 PM
	Black

(E) 42/50HPX95 *web 213:276