TECRA A9, TECRA S5, Satellite Pro S200, Satellite Pro A150

BIOS Setup Program

Settings for some features are carried out in the BIOS setup program.

Notes Before Using the BIOS Setup Application

■In most cases, changes to the system’s configuration should be made within Windows by using applications such as TOSHIBA HW Setup, TOSHIBA Password Utility, Windows Device Manager and so forth. If you make changes to the configuration through the BIOS setup program, please be aware that the configuration set through the Windows applications will take priority.

■Changes to the settings within the BIOS setup program will not be erased even if the power supply is turned off and the main battery removed. However, if the built-in Real Time Clock (RTC) battery runs out of power, most of the settings will revert back to their default values. However, please note that the following items will not be affected in this instance:

•Password

•Hard Disk Drive Password

•Security Controller

•Fingerprint patterns

Starting and Ending the BIOS Setup ProgramStarting the BIOS Setup Program

1.Turn on the computer while pressing the ESC key - if the Password = prompt is displayed, enter either the Supervisor Password, if one is set, or the User Password and press the ENTER key. Please refer to Chapter 6, the TOSHIBA Password Utility for further details about the User Password.

2.At the Check system. Then press [F1] key. prompt, press the F1 key - the BIOS setup application will start up.

Please refer to the operating instructions displayed in the settings screen.

Ending the BIOS Setup Program

In order to save the changes you have made and end the BIOS setup application, follow the steps as detailed below:

1.Press the END key - this will cause the Are you sure? (Y/N). The

changes you made will cause the system to reboot. prompt to be displayed at the bottom of the screen.

2.Press the Y key - this will save the configuration changes and end the BIOS setup application, automatically restarting the computer.

7-8

User’s Manual