Toshiba A9, Pro S200, SATELLITE PRO A150, TECRA S5 manual 170

TECRA A9, TECRA S5, Satellite Pro S200, Satellite Pro A150

External monitor

Please also refer to Chapter 3, Hardware, Utilities and Options, and to the documentation supplied with your monitor for further information.

Problem	Procedure
Monitor does not	After confirming that the monitor’s power switch
turn on	is on, you should check the connections to make
	sure that the power cord/adaptor is firmly
	connected to the monitor and to a working power
	outlet.
No display	Try adjusting the contrast and brightness controls
	on the external monitor.
	Press the FN + F5 hot key in order to change the
	display priority and ensure that it is not set for the
	internal display only.
	Check to see if the external monitor is connected.
	When the external monitor is set as the primary
	display device in extended desktop mode, it will
	not display when the computer wakes up from
	Sleep Mode if the external monitor is
	disconnected while in Sleep Mode.
	To keep this from happening, do not disconnect
	the external monitor when the computer is in
	Sleep or Hibernation Mode. Remember to turn off
	the computer before disconnecting the external
	monitor.
	When the display panel and an external monitor
	are set to clone mode and they are turned off by
	the timer, the display panel or the external
	monitor may not display when turned on again.
	If this occurs, press FN + F5 to re-set the display
	panel and the external monitor to clone mode.
Display error occurs	Check that the cable connecting the external
	monitor to the computer is firmly attached.
	If you are still unable to resolve the problem,
	contact your reseller, dealer or service provider.

8-20 User’s Manual