Toshiba B-EV4 manual Replacing the Important Parts

3. REPLACING THE IMPORTANT PARTS

EO18-33025

(Revision Date: Mar. 27, 2009)

3.12 Replacing the Feed Gap Sensor (Lower)

9.After replacing, perform a feed gap sensor (lower) calibration with the button of the printer or the B-EV4 Setting Tool. Failure to do this may cause a sensor error. Regarding the calibration with the button of the printer, refer to the Owner’s Manual. Regarding the calibration with the B-EV4 Setting Tool, refer to the B-EV4 Setting Tool Specification posted on the Barcode Knowledge Pot.

URL of Barcode Knowledge Pot http://barcode.toshibatec.co.jp/Ris/products/barcode/support/en/index.php

10.Also, make sure the feed gap sensor performs correctly for the following points.

•When the PC connected to the printer sends sample data to the printer, printing is performed correctly. (Specify the feed gap sensor as the media sensor.)

•When the [FEED] button is pressed during the unloading of a media, the status lamp flashes in red.

3-25