Toshiba B-EV4 manual Replacing the Important Parts

3. REPLACING THE IMPORTANT PARTS

EO18-33025

(Revision Date: Mar. 27, 2009)

3.3 Replacing the Main PC Board

6.Replace the main PC board with a new one, then reassemble in the reverse order of removal.

7.After replacement, perform the following operations.

●Perform a media sensor calibration with the button of the printer or B-EV4 Setting Tool.

Regarding the media sensor calibration, refer to the Owner’s Manual or the B-EV4 Setting Tool Specification posted on the Barcode Knowledge Pot.

URL of Barcode Knowledge Pot: http://barcode.toshibatec.co.jp/Ris/products/barcode/support/en/index.php

●Perform a printer parameter setting with the B-EV4 Setting Tool.

●Perform an interface setting (RS-232C, Eternet) with the B-EV4 Setting Tool. NOTE: It is possible to save/upload the printer parameter and interface setting

into/from the PC with the B-EV4 Setting Tool.

8.Also, make sure the printer performs correctly for the following points.

•The sensor adjustment is performed correctly.

•Printing is performed correctly during the diagnostic test print.

•When the PC connected to the printer sends sample data to the printer, printing is performed correctly.

NOTE: Firmware download onto the Main PC board

Perform a firmware download onto the Main PC board if necessary (in the case of alteration/addition to the specification).

Regarding the download procedure, refer to Firmware Down Loading Procedure which is posted on the Barcode Knowledge Pot. The firmware program to be downloaded is also available from this website.

3-8