2. ELECTRONICS SPECIFICATIONS
2.3 Description of the Main PC Board
JP24 (Stepping Motor Thermistior):
Signal | Pin | |
No. | ||
| ||
MOTOR TEMP | 1 | |
GND | 2 |
This connector is connected to the Stepping Motor Thermistor. MOTOR TEMP signal is temperature of the stepping motor.
JP28 (Feed Key/Status LED): | This connector is connected to the Feed Key and Status LED. | |||
|
|
|
|
|
| Signal | Pin |
|
|
| No. |
|
| |
|
|
|
| |
| +3.3V | 1 |
|
|
| GREEN_LED | 2 |
|
|
| RED_LED | 3 |
|
|
| T_KEY | 4 |
|
|
| GND | 5 |
|
|
JP29 (Feed Gap Sensor, Lower): This connector is connected to the Lower Feed Gap Sensor (Photo Diode).
Signal | Pin | |
No. | ||
| ||
+3.3V | 1 | |
GAP_E | 2 |
Print Head (JP30):
Signal | Pin | |
No. | ||
| ||
VH (+24V) | 1 | |
VH (+24V) | 2 | |
TM | 3 | |
TM | 4 | |
/STB2 | 5 | |
GND | 6 | |
GND | 7 |
Signal | Pin | |
No. | ||
| ||
GND | 1 | |
GND | 2 | |
VDD (+5V) | 3 | |
/STB1 | 4 | |
/LAT | 5 | |
CLK | 6 | |
DI | 7 | |
VH (+24V) | 8 | |
VH (+24V) | 9 |
This connector is connected to the print head (for TS model, 300dpi). The voltages and signals for controlling the print head are input/output into/from the connector.
