4 Replacement Procedures

4.9 Optical Drive

Reassembling the Optical Drive

NOTE: The small arrow shown on the metal bracket indicates the top side of the optical bracket. Keep this in mind when removing or installing the drive.

To reassemble an optical drive, follow the steps below and refer to the figure in the preceding section.

1.Position the optical drive bracket plate so that it is aligned with the rear panel of optical drive.

2.Secure the optical drive bracket plate with two M2x2.5 screws.

3.Install the optical drive module into the bay as described in the preceding section.

4-26

[CONFIDENTIAL]Satellite P200/ P205 Series Maintenance Manual

Page 148
Image 148
Toshiba P205 manual Replacement Procedures Optical Drive, Reassembling the Optical Drive