Toshiba R410A 4 2 5, How To Operate Air Conditioner, Cool/Heat Auto, Heat, Dry, Cool, Fan

HOW TO OPERATE AIR CONDITIONER

COOL/HEAT AUTO, HEAT, DRY, COOL, FAN

1 Power supply

Turn on the power supply of the air conditioner 12 hours before starting the operation.

2 Push button.

3

Push button () to select fan speed.

When selecting AUTO, fan speed is automatically changed.

(During FAN mode, the air speed is not.)

80

TEST

SETTING

3

˚C ˚F

4

2

5

4

5

Push either or set to Auto.

<Recommended temperature>

•During FAN mode, the temperature cannot be set up.

Stop

Push button.

When stopping the unit by the remote controller, the fan of the outdoor unit, the fan or the outdoor unit may keep operating for a while even if the compressor of the outdoor unit has stopped.

•When the unit cannot be stopped by the remote controller.

Turn off the main power switch or the leakage breaker, and then contact the shop which you purchased the unit.

•In heating, if the room is not enough heated with FAN , select FAN or .

•As the temperature sensed by the temp. sensor periphery of the suction port of the indoor unit, it differs from in the room according to the installation state. Set the tempera- ture considering the setup value as the standard temperature in the room.

Automatic Cool/Heat

When all indoor units in the identical refrigerant system are controlled as a group and when all indoor units are installed in the same room, the cooling or heating operation is automati- cally performed with the difference between the setup temperature and the room tempera- ture.