Toshiba R410A service manual Operation section

Operation section

Push each button to select a desired operation.

•The details of the operation needs to be set up once, the same states are used by pushing button.

		1	7
2			8
			9
3
4			UNIT
5	SET	CL	10
		6

1	Fan mode button	8	button
	Selects a fan mode.		When the button is pushed, operation starts,
2
	Timer set button		and it stops by pushing the button again.
	TIMER SET button is used when the timer is		When the operation stops, the operation lamp

set up. and all displays disappear.

3 Check button

CHECK button is used for check operation. During normal operation, do not use this button.

4 Fan button

FAN button is used when a fan which is sold on the market or etc. is connected.

•If “No function” is displayed on the remote controller when pushing the FAN button, a fan is not connected.

5 Filter reset button

Resets (Erases) “FILTER ” display.

6 UNIT and AUTO flap button No function

7 Operation lamp

Lamp is lit during the operation. Lamp is off when stopped.

It flashes when operating a protection device or abnormal occurred.

9 Operation select button

Selects operation mode.

10 Set up temperature button

Adjusts required room temperature.

Set required set temperature by pushing

or .

FILTER UP/DOWN button

(No function display)

OPTION :

Remote controller sensor

Usually the TEMP. sensor of the indoor unit mea- sures a temperature. A temperature around the remote controller can also be measured.

For details, contact the dealer from which you have purchased the air conditioner.

35