Concealed Duct High Static Pressure | Installation Manual |
|
9 APPLICABLE CONTROLS
REQUIREMENT
•When you use this air conditioner for the first time, it takes approx. 5 minutes until the remote controller becomes available after
<When power is turned on for the first time after installation>
It takes approx. 5 minutes until the remote controller becomes available.
|
|
|
|
| Approx. 5 minutes | ||
|
|
|
|
|
|
|
|
Power on |
|
| “SETTING” |
| “SETTING” |
| Remote |
|
| flashes |
| goes out |
| controller is | |
|
|
|
| ||||
|
|
|
|
|
|
| available |
|
|
|
|
|
|
|
|
<When power is turned on for the second (or later) time>
It takes approx. 1 minute until the remote controller becomes available.
|
|
|
|
| Approx. 1 minutes | ||
|
|
|
|
|
|
|
|
Power on |
|
| “SETTING” |
| “SETTING” |
| Remote |
|
| flashes |
| goes out |
| controller is | |
|
|
|
| ||||
|
|
|
|
|
|
| available |
|
|
|
|
|
|
|
|
•Normal settings were made when the indoor unit was shipped from factory.
Change the indoor unit settings as required.
•Use the wired remote controller to change the settings.
*The settings cannot be changed using the wireless remote controller, sub remote controller, or remote-
Procedure 1
Push button and TEMP. button simultaneously for at least 4 seconds.
After a while, the display flashes as shown in the figure. Confirm that the CODE No. is [01].
•If the CODE No. is not [01], push button to erase the display content, and repeat the procedure from the beginning.
(No operation of the remote controller is accepted for a while after button is pushed.)
(* Display content varies with the indoor unit model.)
Procedure 2
Each time you push button, indoor unit numbers in
the control group change cyclically. Select the indoor unit you |
|
want to change settings for. |
|
The fan of the selected unit runs. You can confirm the indoor |
|
unit for which you want to change settings. | EN |
|
Procedure 3
Using TEMP. / buttons, specify CODE No. [ ].
Procedure 4
Using TIME / buttons, select SET DATA
[ ].
!Changing of setting applicable control
Basic procedure for changing settings
Change the settings while the air conditioner is not working. (Be sure to stop the air conditioner before making settings.)
Procedure 5
Push button. When the display changes from flashing to lit, the setup is completed.
•To change settings of another indoor unit, repeat from Procedure 2.
•To change other settings of the selected indoor unit, repeat from Procedure 3.
Use button to clear the settings.
To make settings after button was pushed, repeat from Procedure 2.
4 |
6 |
1 | 5 | 2 |
1
3
– 28 – |