Toshiba RAV-SM2242DT-E 8C Operation, Procedure, Concealed Duct High Static Pressure, 34-EN

Concealed Duct High Static Pressure

!8°C Operation

Pre-heating operation can be set for cold regions where room temperature drops to below zero.

Procedure 1

Push simultaneously + + buttons for 4 seconds or more when the air conditioner is not working.

After a while, the display part flashes as shown below. Check the Displayed CODE No. is [10].

•When the CODE No. is other than [10], push button to erase the display and repeat procedure from the first step.

(After pushing button, operation of the remote controller is not accepted for approx. 1 minute.)

(* Display changes according to the model No. of indoor unit.)

Procedure 2

Every pushing button, the indoor unit No. in the group control is displayed in order. Select the indoor unit of which setup is changed. In this time, the position of the indoor unit of which setup is changed can be confirmed because fan of the selected indoor unit operate.

Procedure 3

Using TEMP. / buttons, specify CODE No. [d1].

Procedure 4

Using TIME	/	buttons, select SET DATA [0001].
SET DATA		8°C Operation setting
0000		None
		(Factory default)
0001		8°C Operation setting

Procedure 5

Push button.

In this time, the setup finishes when the display changes from flashing to lighting.

Procedure 6

Push	button.(Setup is determined.)
When pushing		button, the display disappears and the
status
Becomes the usual stop status. (When pushing			button

the operation from the remote controller is not accepted for approx. 1 minute.)

Installation Manual

EN

– 34 – 34-EN