Toshiba RD-XV47KE Installing Batteries in the Remote Control, HDD / DVD / VCR Modes Switching

E3B90ED_EN.book Page 20 Friday, February 23, 2007 12:38 PM

Installing Batteries in the Remote Control

Install two R6 (AA) batteries (supplied) into the remote control, carefully match with the polarity indicated inside the battery compartment.

1 2 3

Caution

•Incorrect use of batteries can result in hazards such as leakage and bursting.

•Do not mix new and old batteries together.

•Do not use different kinds of batteries together.

•Make sure that the + and - ends of each battery match the indications inside the battery compartment.

•Remove batteries if the equipment will not be used for a month or more.

•When disposing used batteries, please comply with governmental regulations or the public instructions for environmental protection that apply in your country or area.

•Do not recharge, short-circuit, heat, burn or disassemble batteries.

About the Remote Control

•Make sure there is no obstacle between the remote control and the remote control sensor on the unit.

•Use within the operating range and angle as shown.

Within about 7 m

30˚

30˚

Remote control

• The maximum operable range as follows:

Line of sight: approximately 7 m

Either side of centre: approximately 7 m within

30degrees

•Remote control operation may become unreliable if the remote control sensor of the unit is being exposed by the strong sunlight or fluorescent light.

•Remote controls for different devices can interfere with each other. Be careful when using remote controls for other equipment located close to the unit.

•Replace the batteries when the operating range of the remote control reduces.

HDD / DVD / VCR Modes Switching

Because this unit is a combination of a VCR, a HDD and a DVD recorder, you must select first which component you wish to operate.

Device Select Buttons / Indicators

	OPEN/	TIMER	INPUT
	CLOSE	PROG.	SELECT
HDD/DVD
	.@/ :	ABC	DEF
	GHI	JKL	MNO	PROG.
	PQRS	TUV	WXYZ	SATELLITE
				LINK
VCR HDD DVD	CHAPTER	SPACE	AV SELECT MODE
	MARK
DVD button / indicator	DISC MENU	SETUP	AUDIO	TOP MENU
	TIME SLIP			CLEAR
HDD button / indicator		ENTER
VCR button / indicator	DISPLAY			RETURN
	SKIP		VARIABLE VARIABLE
			REPLAY	SKIP
	SLOW/REV	PLAY		FWD/SLOW
VCR button	-ADJUST	STOP		ADJUST+
	REC MODE	VCR	HDD	REC
	PAUSE			DVD
HDD button	REPEAT	SEARCH	1.3x/0.8x	DUBBING
			PLAY

DVD button SE-R0274

HDD mode

Press [HDD] on the remote control. (Verify that the HDD indicator is lit.)

DVD mode

Press [DVD] on the remote control. (Verify that the DVD indicator is lit.)

VCR mode

Press [VCR] on the remote control. (Verify that the VCR indicator is lit.)

Note

•If you press [REC I] of each device, recording starts in its device mode.

20 EN