Toshiba RD-XV47KE manual One-touch Timer Recording, Index Search, Time Search, EN101, Press VCR

Press [VCR].

(See page 100.)

E3B90ED_EN.book Page 101 Friday, February 23, 2007 12:38 PM

One-touch Timer Recording

VCR

This feature allows you to set the recording length simply by pressing [REC I].

1 Turn on the unit and insert a recordable tape.

Make sure that the TV input is set on the unit.

2 Press [VCR].

3 Select the recording speed using [REC MODE].

4 Select the desired channel to record using [PROG. / ] or

[the Number buttons].

5 Press [REC I] repeatedly until the desired recording time (15 minutes to 4 hours) appears on the TV screen.

One-touch Timer Recording will start.

0:15

(Normal Recording) 0:30

4:00 3:45

•When the unit reaches the specified time, it will be turned off automatically.

•To change the recording length during One-touch Timer Recording, press [REC I] repeatedly until the desired length appears.

•To cancel One-touch Timer Recording within the specified time, press [STOP S].

Note

•The remaining recording time will appear on the front panel display during a One-touch Timer Recording. Press [DISPLAY] can also see the remaining recording time on the TV screen.

•You cannot pause a One-touch Timer Recording.

•When VCR recording and the Timer Recording are overlapping, the Timer Recording has its priority.

•The unit will automatically switch to the programmed channel 15 seconds before the programmed time, and the VCR recording will be cancelled except when their recording channel is the same. If their recording channel is the same, the Timer Recording will start without cancelling the VCR recording, and the recording will be made on both VCR and the HDD / DVD.

Search

Index Search

VCR

An index mark will be assigned at the beginning of each recording you make. You may skip to a specific marked point by following the steps below.

1 Press [VCR].

2 Press [SEARCH] to display the index search menu.

3 Enter the number of recordings you want to skip using

[the Number buttons] within 30 seconds.

4 Press [FWD / SLOW f] or [SLOW / REV r] to start index search.

If you want to go in the forward direction, press

[FWD / SLOW f].

If you want to go in the reverse direction, press

[SLOW / REV r].

After index search, the VCR will play back the tape automatically.

Note

• This function is not available during recording.

Time Search

VCR

This feature allows you to go to a specific point on a tape by entering the exact amount of time you want to skip in order to reach the point.

1

2 Press [SEARCH] repeatedly until the time search menu appears.

3 Enter your desired time to skip using [the Number buttons] within 30 seconds.

4 Press [FWD / SLOW f] or [SLOW / REV r] to start time search.

If you want to go in the forward direction, press

[FWD / SLOW f].

If you want to go in the reverse direction, press

[SLOW / REV r].

After time search, the unit will play back the tape automatically.

Note

•This function is not available during recording.

•Press [STOP S] to stop the search.

•If the tape reaches the end during the Search, this unit will cancel it and rewind the tape.

EN101

Introduction Connections Basic Setup Recording Playback

Editing Function Setup VCR Functions Others