Toshiba RD-XV47KE manual Manual Clock Setting, Select On using Cursor U / D, then press Enter

Off

6 Press [SETUP] to exit.

7 Press [ ON / STANDBY] to turn the unit to standby mode.

The Auto Clock function is activated.

This unit will search for the time only when the unit is in standby mode. Leave the unit for several minutes to give it time to set the clock.

Note

• If you want to cancel “Auto Clock Setting”, select “Off” using [Cursor U / D] at step 5, and then press [ENTER].

• The default setting of “Auto Clock Setting” is “On”.

• The clock may set itself automatically after you connect the antenna cable to the unit and plug in the mains cable. In this case, the current time will appear on the front panel display.

• To set the clock automatically, the channel assigned to “P01” must receive the PDC signal and the Decoder must be Off.

• The clock cannot be set automatically if you are not receiving a channel in your area that carries a time signal. In this case, set the clock manually.

• Once the auto clock setting is performed, the unit will correct the current time by receiving PDC broadcasts whenever the unit is in standby mode.

• The unit will correct the current time automatically at 8:00, if the unit is in standby mode.

• From 23:00 to 1:00, the Auto Clock function will not operate even if the unit is in standby mode.

E3B90ED_EN.book Page 31 Friday, February 23, 2007 12:38 PM

5 Select “On” using [Cursor U / D], then press [ENTER].

	Initial Setting		--/--/--(---) --:--
OSD Language
Clock Setting				Clock Setting
Channel		Setting		Auto Clock Setting
TV Aspect			Auto	Clock Setting
Select Video
Video Out				On

Manual Clock Setting

1 Follow the steps 1 to 3 in “Auto Clock Setting” on page 30.

2 Select “Clock Setting” using [Cursor U / D], then press [ENTER].

	Initial Setting	--/--/--(---) --:--
OSD Language
Clock Setting			Clock Setting
Channel Setting
			Auto Clock Setting
TV Aspect
Select Video
Video Out

3 Move to the item you want to set using [Cursor L / P], and change the setting to suit your preference using [Cursor U / D].

Clock Setting				----/--/--(---)	:--
		Clock Setting
	-- /	-- /----	(--) --	: --

4 When all the information is entered, press [ENTER].

Your setting is now activated.

Although seconds are not displayed, they will be counted from zero.

5 Press [SETUP] to exit.

Note

•Your clock setting will be lost if either there is a power failure or this unit has been unplugged for more than 30 seconds.

EN 31

Introduction Connections Basic Setup Recording Playback

Editing Function Setup VCR Functions Others